Skull and Crossbones Greetings

I found some left over Love Letter DSP from a previous project!!! Here's the card that was created using scraps.
The main (center) black/vanilla DSP is 5" x 4-1/4"
The houndstooth DSP and words DSP trims are both 1/2" x 4-1/4"
Attach all pieces, then wrap the grosgrain ribbon on the side before popping with dimensionals to attach to the card front.

Here's a closer view of the skull and crossbones: see the red adhesive rhinestones in the eyes? Pop this with dimensionals on top of a 2" Black circle which is attached to a 2-1/2" Cherry Cobbler circle. Pop the 2-1/2" Cherry Cobbler Circle with dimensionals, then attach to the scallop DSP circle. "BOO" is using a white gel pen - hand writing is OK here.........................

Card inside:
Stamp "scary" message on 4" x 5-1/4" Very Vanilla CS using Black ink. The trim used for top and bottom is 1/2" x 4" for the Love Letter DSP and the Cherry Cobbler trim is 1/4" x 4".

Supplies:

• Stamps: Scary (non SU)
• CS: Cherry Cobbler, Black, Very vanilla, Love Letter DSP
• Ink: Black
• Accys: Crossbones die (non SU), Circle Scissor Plus, Big Shot Sizzix Scallop Circle #2 Die, Dimensionals, 5/8" Black Grosgrain Ribbon, Dimensionals, White Gel Pen, Red Adhesive Rhinestones

Thank you for stopping by today...............................