Lollypop Flower Favor

Here are the cute Tootsie Pop Flowers I made today. These were inspired by a swap I received at Leadership. I don't have the Big Shot Flower Folds Die so I used a punches to make this. One Flower pop is using solid CS while the others are using that fabulous new DSP: Sending Love.

Here the flowers sit in a small glass container:

Here's the underside of the flower:

To make these flowers:

Left Photo:

(3) Punched full hearts in Real Red CS

(1) Punched Extra Large Fancy Flower in Pretty in Pink CS
(1) 1-1/4" x 3-1/2" Old Olive CS

Right Photo: Trim hearts 1-1/2" from the point of the heart as shown

Left Photo: Clip hearts as shown about 1/2"

Right Photo: Clip Punched Flower as shown, about 1/2"

Left Photo: Using the Crop-o-dile large hole, punch center

Right Photo: Sponge edhes of the Flower using Real Red ink

Left Photo: after thread the Tootsie Pop stick through, adhere the hearts around the stick using sticky tape. Tip: use invisible tape to tightly wrap around the Tootsie Pop wraper.

Right Photo: Light mark, with a pencil 1/2" as shown. (width of Old Olive strip shuld be 1-1/4" not 2" as in photo)

Left Photo: clip the Old Olive 1/8" apart to the pencil line.

Right Photo: Apply sticky tape on one side to adhere to the Tootsie Pop stick and on the other side to "close" the Old Olive strip. Tie ribbon around stick.

Supples:

• Stamps: none
• CS: Real Red, Pretty in Pink, Senmding Love DSP
• Ink: Real Red
• Accys: Full Heart Punch, Extra Large Fancy Flower, Stamping Sponge, Sticky Tape, 1/4" Old Olive Grosgrain Ribbon

Thank you for stopping by to see my project today...............HUGS!!!